Suitable for Rolls-Royce & Bentley models between:

- 1965-1980 (From VIN 11800 onwards)

- 1980-2003 (From VIN 1001 up to 27798)

 

This information is taken from Workshop Manual TSD2476, Section H.

1. Press the new bearing outer races squarely into the hub with the smaller end of the taper bore leading. Ensure that the races are fully seating on the rear shoulders of the hub.

2. Lubricate the new inner races and roller cages with the approved grease and fit them to the mating outer races in the hub.

Note: When fitting bearings to more than one hub at a time, ensure that each bearing set remains separate from the other set, as all bearings are supplied in matched sets.

3. Press the correct grease retainer squarely into position in the hub until the leading edge abuts the bearing outer race.